Taking part in in Mud – How one can Mix Drywall Joint Compound. Sand the compound easy, then apply one other layer of joint compound, using a 6- or 8-in. Measure, minimize and set up new drywall to suit the restore area (picture 2). Make sure you use drywall that matches the unique wall thickness. Set the drywall patch in place and screw it into the furring strips, sinking the screws beneath the floor of the drywall.
Set up wooden cleats towards the studs on each side of the opening to help the new drywall’s vertical edges (picture 1). Use scrap wooden corresponding to 1×2 furring for smaller repairs; if you’re changing a large sheet of drywall, reinforce the opening with 2×3 lumber.
House interiors are usually covered with half of-inch-thick drywall, however sure areas, comparable to between a house and attached garage, require thicker, fire-rated drywall. Even a chunk of scrap drywall will work, as long as it has straight edges. Finish all repairs with a last gentle sanding to make sure a satin easy finish and seamless blending between the patch and the wall.
The second and third coats are to blend and smooth the taped joints in order that they’ll be invisible when painted. Scrape away any loose compound, and use a razor knife or drywall noticed to expand the crack by way of the wall surface into the stud cavity (picture 3). Avoid removing stable, effectively-adhered compound past the crack itself.
When utilizing drywall screws, you should definitely recess the heads barely, creating a dimple within the drywall surface that can be covered with joint compound, but be careful to not tear through the paper floor. Score alongside the edge of the bead about 1¼” again from the nook.